Expert Answers about Chevrolet Exhaust Systems

• Will Installation of MagnaFlow Exhaust on 2008 GMC Sierra Cause Engine Light To Come On
• When installing the MagnaFlow Exhaust System, part # MF18915, on your 2008 GMC Sierra 2500/3500 V8 6.6L, the first step is to disconnect the vehicle's battery before removal of the OEM exhaust. This will allow the computer to reset itself with the new system, and keep the engine light from coming on. It will also help prevent electrical accidents. I am including a link to the installation instructions on the MagnaFlow exhaust that will help you with the installation of the exhaust system.
  view full answer...


• Does MagnaFlow Exhaust Restrict Air Flow on a 2014 Chrysler 300S V6
• The MagnaFlow exhaust system # MF15119 for your 2014 Chrysler 300S V6 does not restrict exhaust flow. If you used the same configuration with the stock exhaust parts on the vehicle then that would restrict it some. But the MagnaFlow mufflers have no baffles, chambers or louvers and the pipes maintain the same diameter in the bends allowing the exhaust to flow more freely through the system.
  view full answer...


• Do I Need to Remove the Exhaust on My 2011 Subaru Forrester to Install Curt Hitch # 13147
• You may only need to lower the exhaust system on your 2011 Subaru Forester to install this Curt Hitch, part # 13147. The mechanic maybe did not realize that you only had to lower it temporarily, and he thought you had to remove the whole system. Or maybe he did not realize that if you unhook the four rear exhaust hangers the exhaust will drop enough to allow you to install the hitch. The exhaust will have to be supported at this point to prevent any damage from being done to the exhaust. I...
  view full answer...


• Can Rock Tamers Mud Flap System Work On 2014 Dodge Ram With Rear Exhaust
• The Rock Tamers Heavy-Duty, Adjustable Mud Flap System, part # ERT00108 will work with the exhaust on your 2014 Ram truck. I have attached a photo that shows the system installed on a truck with rear exhaust like you said you have. The arms of the mud flaps can extend so the mud flaps are not directly behind the exhaust.
  view full answer...


• Will a Resonated Exhaust Tip Make my 2011 Infiniti G37 Louder
• The Bully Round Exhaust Tip part # PM-5104 has a resonated body which will provide a slightly more "crackly" sounding exhaust for your 2011 Infiniti G37 but will not exactly make it any noticeably louder. As long as your exhaust piping is between 1-3/4" to 2-1/2" in diameter then the above exhaust tip will work well for you. To really get the greatest sound output out of your 2011 Infiniti G37 with the 3.7L V6 engine you will want to install a MagnaFlow Exhaust System like part # MF16820....
  view full answer...


• How To Install Camco Gen-Turi RV Generator Exhaust System On Motorhome With Turn Down Exhaust
• In order to install the Camco Gen-Turi RV Generator Exhaust System part # CAM44461 on a motorhome where the exhaust pipe is turned down towards the ground you'll need to cut that section of the exhaust pipe off. Once this is done, you can use the Camco Gen-Turi Replacement 30" EMT Straight Discharge Pipe part # CAM44802 to lengthen the connection if needed.
  view full answer...


• Is Exhaust System Permanently Lowered to Install Blue Ox Gooseneck on 2013 Dodge Ram MegaCab
• I spoke with my contact at Blue Ox about your 2013 Dodge Ram Mega Cab and the exhaust. They do furnish replacement hangers for the exhaust with the DH1102 Hitch. My contact told me that the hangers are adjustable and depending on the installation, the exhaust could be as much as 3 inches lower. I have attached a photo that shows the hangers in the kit and the dimensions when they are retracted and fully extended. I have also included a video that shows this hitch being installed. If clearance...
  view full answer...


• Is Welding Required to Install MagnaFlow Cat-Back Exhaust System 16869 on a 2010 Dodge Ram
• The installation of MagnaFlow exhaust system # MF16869 does not require any welding. The new parts are all held together with clamps. I have included a link to the installation instructions for you to view.
  view full answer...


• Does the Factory Exhaust Need to Be Cut Off To Install a Magnaflow Cat-Back System on a 2006 BMW M5
• To install this MagnaFlow Cat-Back Exhaust System # MF16859 on your 2006 BMW M5 you will need to cut your old exhaust off. To install the new stuff you will use the included clamps. You would not need to weld anything. Check out the installation instructions for the product that I attached.
  view full answer...


• Will the Cat Back Exhaust System for the 2000 Honda Accord Pass Emissions
• The MagnaFlow Stainless Steel Cat-Back Exhaust System - Gas, item # MF15690, for the 1998 - 2000 Honda Accord L4 2.3L Sedan will pass emissions testing as long as the vehicle it is installed on is in proper running condition to pass the emissions testing for the state you live in. Emissions are improved by the catalytic converter and systems on the engine of the vehicle. The Cat-Back Exhaust System will in no way improve emissions of the vehicle.
  view full answer...


• Magnaflow Cat Back Exhaust for 2001 Pontiac Trans AM
• The Cat Back Exhaust system will bolt up to the catalytic converter extension pipe with no modifications needed. However, in order to remove the existing exhaust, cutting the over the axle pipe just to the rear of the axle will be required (unless you feel brave enough to lower the rear axle). The system uses clamps, no welding is required. For your convenience, I will include a link to the installation instructions. You can find the link below.
  view full answer...


• Difficulty of Relocating Exhaust Hanger for Hitch Installation on 1999 Mercury Grand Marquis LS
• Installation of the Curt Class III trailer hitch # 13707 that you referenced will require exhaust hanger modification on your 1999 Mercury Grand Marquis LS with dual exhaust. The hanger is essentially a steel rod that connects with a rubber shock mount to the exhaust. The steel hanger is what will need to be relocated. This is best done by a qualified welder and will allow enough clearance between the exhaust and the hitch. The process is not especially complicated but for safety reasons...
  view full answer...


• Will the MagnaFlow Turndown Cat-Back Exhaust System Install on a Stock 2011 GMC Sierra 1500
• You can install the MagnaFlow Turndown Cat-Back Exhaust System, # MF17101, on your stock 2011 GMC Sierra 1500 without lowering or lifting the vehicle body or suspension. This exhaust system was designed to fit the following engine sizes for the 2011 GMC Sierra 1500: V6 4.3L Regular Cab V8 4.8L Regular Cab V8 5.3L Regular Cab One thing you should keep in mind is that this exhaust system was designed for off road use only and should not be used when on public roads or highways. If you...
  view full answer...


• Should I Replace the Mufflers or Resonators on a 2010 Jeep Grand Cherokee with 5.7L V8
• In order to have the MagnaFlow Stainless Steel Muffler part # MF12586 installed on your 2010 Jeep Grand Cherokee you will need to take your vehicle to a local exhaust shop. Your Grand Cherokee has a resonator in the middle of the exhaust and a muffler at the end of the exhaust just before the tail pipes. The MagnaFlow Stainless Steel Muffler will need to replace the muffler at the end of the exhaust.
  view full answer...


• Will the Camco Gen-Turi RV Generator Exhaust System Create An Issue With Roof Vents
• The Camco Gen-Turi RV Generator Exhaust System part # CAM44461 won't create any issues for the roof vents. The only thing you'd need to watch out for is a vent with electric fan that is reversible. In which case, you would not want to be using the vent on that settings if the unit is close to the Gen-Turi while the generator is running.
  view full answer...


• Can Camco Gen-Turi RV Generator Exhaust System Bushings Be Welded On For Installation
• I reached out to Camco regarding a weld-on installation of the bushings for the Gen-Turi RV Generator Exhaust System # CAM44461. According to my contact, this is a perfectly acceptable way to install the system. When possible, welding will always outperform something like the clamps that are included when performed by a professional. That would be the most secure way to install this and remove any need for concern.
  view full answer...


• Are There Clamps that come with the MagnaFlow Competition Series Cat-Back Exhaust System?
• I contacted our representative at MagnaFlow, and they confirmed that all the parts that come with the MagnaFlow Competition Series Cat-Back Exhaust System - Stainless Steel - Gas # MF16483 is for stock accessories/parts. If there are any mods, you might need to have additional clamps for the specific modifications you have. If you have the factory parts, the Cat-Back Exhaust system will come with all the parts you need. If you have any mods, I would be happy to assist you in finding a solution.
  view full answer...


• How to Prevent A/C from Bringing in Exhaust from the Camco # CAM44461
• In order to ensure that the exhaust from the Camco Gen-Turi RV Generator Exhaust System # CAM44461 does not enter into your A/C, there is definitely one thing you can do to ensure it doesn't enter your system. For a guaranteed way, I recommend selecting the "internal air circulation" option that comes standard on most vehicles. The button for this is usually found near your A/C controls for the vehicle and usually has a symbol of a half arrow inside of a car. With this option, the A/C will...
  view full answer...


• Does the Air Force One Activate the Towed Vehicles Brakes When the Exhaust Brake Is Used
• The Demco Air Force One Supplemental Braking System # SM99243 is actually the perfect solution for you since it does not engage the brakes on your toad when the brake lights on your coach are lit; it instead relies on the the coach's air brakes to be activated and will prevent false braking that occurs with other systems that react to the brake light signals. Because of this, when you use the exhaust brake instead of the coach's air brakes, it will not create a situation where the toad's...
  view full answer...


• Replacing The Quick Exhaust Valve On A Roadmaster Even Brake Portable Breaking System
• The Replacement Quick Exhaust Valve for Roadmaster BrakeMaster or Even Brake Supplemental Braking System # RM-450601-50 can be installed in your Roadmaster Even Brake Portable Supplemental Braking System - Proportional # RM-9400 by first removing the bottom plate to gain access to the valve. You can then remove the air line and unthread the valve to swap it out with the new replacement valve. I've attached a video below where David will walk you through replacing this part on your Roadmaster...
  view full answer...